Table of Contents
Advertisement
B. CONNECTING THE SRL TO A HARNESS
All 400X series SRL's can be connected directly to the harness webbing at
the back D-Ring location utilizing the 4007-65 Connector (Figure 6).
1. Remove clevis connector from top of SRL case. (Up to 2 units may be
connected to the anchor loop of the 4007-65 adaptor bracket) Pass
clevis('s) through the 4007-65 anchor loop and reinstall anchor pin through
clevis and secure anchor pin with the supplied safety locking pin (Figure 7).
2. Open bail connector by turning the knurled knob 90 degrees and pulling the
spring loaded pin back and allowing the locking pin to lock open.
3. Pull both webbing shoulder straps located at the back D-Ring away
from the black back plaque. Pull enough slack to allow the insertion
of the bail connector through the webbing. Both web straps must be
captured by the bail connector (Figure 8).
4. Pass bail connector behind webbing and close locking pin by aligning
locking pin with the hole in the bail connector (Figure 9).
5. Twist knurled knob to release the spring loaded pin. Ensure pin is fully
inserted into the bail connector hole and locks against the center barrel
(Figure 10). CAUTION: The Bail Arm of the 4007-65 Connector is for
attachment to harness webbing only. DO NOT use metal connectors
such as a bow shackle or screw-lock link to secure in place. DO NOT
attach Connector directly to d-ring.
Bail Connector
Knurled Knob
Figure 6
Figure 7
Locking Pin
Anchor Loop
Figure 8
Instructions for Use
NOTE: A single 400X series SRL
may be connected to the dorsal D-
ring of a harness using an approved
carabiner (#3062), provided no other
snaphooks or carabiners are already
connected to the D-ring. If two 400X
series SRL's are to be connected to
a dorsal D-ring, they MUST be con-
nected using the 4007-65 connector.
Figure 9
Figure 10
Page 15
Advertisement
Table of Contents
