Table of Contents
Advertisement
Do Not connect the Tie-Back Snap Hook
above the EZ-Grip Cable Pull. Do NOT
connect to any thimble. Failure to connect
only to Tie-Back Blue Vinyl Cable of the
SRL may result in serious injury or death.
A. CONNECTING THE SRL-LE TO AN ANCHOR POINT
NOTE: Approved fall protection must be worn during Skyloc™ Self-
Retracting Lanyard installation at all times. Do not use the SRL as a method
of personal fall protection until the system has been completely installed,
inspected, and approved for use by a Qualified Person.
1. Installation of the Roto-Loc™ Leading Edge Self-Retracting Lanyard
begins with the identification of a suitable anchor point. The anchor
point must be capable of supporting a 3,600 lb (16kN) load where
certification of load carrying ability exists, or 5,000 lb (22.2kN) where
certification does not exist. NOTE: These strengths must be multiplied
by the number of persons that will be connecting to the anchorage
point at any one time.
2. Pass a large carabiner or bow shackle (or other Reliance approved
connecting means) through the swivel eye or handle at the top of
the Roto-Loc™. This carabiner or bow shackle must be rated with a
minimum breaking strength of at least 5,000 lb (22.2kN) and must be
used for connecting to only 1 SRL at a time.
3.Secure the bow shackle or carabiner to the anchor point. If using bow
shackle, verify that it is a safety shackle and that the nut of the shackle
has been fully captured using a clevis pin or lock ring to prevent
accidentally disengagement. When using a carabiner make sure that
the gate has fully closed and rotated into a locked position.
B. HARNESS MOUNTING THE SRL-LE WITH 3020
44XXXXX Series ROTO-LOC™ SRL-LE'S can be connected directly to
the harness webbing at the back D-Ring location utilizing the 3020 Con-
nector (Figure 5).
1. Depress the lock button, and pull open the locking pin. (Fig 6)
2. Insert the open end of the frame through the clevis connector of the first
SRD, and through the clevis connector of the second SRD (if present).
(Fig 7 & 8)
3. Pull both webbing shoulder straps in the back D-Ring into a loop away
from the black back plaque. Pull enough slack to create a loop large enough
Page 14
WARNING
INSTALLATION PROCEDURE
Advertisement
Table of Contents
