Toshiba 15LV505-T Owner's Manual page 63

Disc playback setup
Parental
A DVD is usually encoded with a rating level to indicate
the recommended audience age. You have the option to
select the content rating level allowed for playback in
your TV/DVD.
You will be prompted to key in the system password to
access this settings option. Press  or  to select the
allowable rating level, then press ENTER.
Off No playback restriction. All discs can be
played regardless of content rating.
Level 1–5 Discs of varied non-adult ratings will be
played back. The higher the number, the
more severe the content is.
Level 6–8 Discs of varied adult only ratings will be
played back.
Notes:
• The Parental rating levels correspond to the US movie
ratings.
Level 1 – Kid Safe Level 5 – PG-R
Level 2 – G Level 6 – R
Level 3 – PG Level 7 – NC-17
Level 4 – PG-13 Level 8 – Adult
• Some discs may not have their rating level encoded on
the disc though it's indicated on the disc jacket.
Playback restriction will not apply to these discs so
make sure to restrict access to it manually.
To temporarily cancel the parental restriction:
1) Load the restricted content DVD that you want to play.
2) Use the Number buttons (0–9) to input the system
password after the "Enter Password" message, then
press ENTER.
This suspension of the parental restriction setting
only applies until the disc is ejected.
(continued)
Parental Menu E.B.L. DRC : Off : English : Off :Off
Password :Change
Subtitle TV Screen QSound : 4:3 : English : On
Audio Display : On : English
Picture Mode : Auto
JPEG Interval : 5 Seconds
Screen Saver : On
Password
Select this option to change the access password for the
parental control setting.
1) Press  or  to select "Password", then press
ENTER.
2) Use the Number buttons (0–9) to input the current
password, then press ENTER.
If the password has not been set yet key in "0000".
This is the factory default password.
3) Use the Number buttons (0–9) to input the new
password, then press ENTER.
You will be prompted to confirm the new password.
4) Use the Number buttons (0–9) to input the new
password again, then press ENTER.
5) Press ENTER one last time to confirm the changed
password. Note this new password for future
reference.
If you forget the system password:
1) Make sure there is no disc in the disc slot.
2) Press and hold down "4" on the remote control, then
press VOL- on the unit.
The "Initializing" message appears on-screen to
indicate that the password has been reset to its
default factory setting "0000". All DVD Setup-related
settings will also be reset to their default factory
values.
EJECT
0-9
ENTER
RETURN
63