Power Source - Toshiba 15LV505 Owner's Manual

Connecting to optional equipment (Continued)/

Power source

Connecting to an amplifi er equipped with a digital audio input
2 channel digital stereo
You can enjoy the dynamic sound of 2 channel digital stereo by connecting an amplifi er equipped with a digital audio input and speaker
system (right and left front speakers).
Note: PCM audio is limited to DVD or CD playback.
Amplifi er equipped with a
To COAXIAL
type digital
audio input
Note:
• DO NOT connect the COAXIAL DIGITAL AUDIO OUT jack of the TV/DVD to the AC-3 RF input of a Dolby Digital Receiver.
This input on your A/V Receiver is reserved for Laserdisc use only and is incompatible with the COAXIAL DIGITAL AUDIO OUT jack
of the TV/DVD.
• Connect the COAXIAL DIGITAL AUDIO OUT jack of the TV/DVD to the "COAXIAL" input of a Receiver or Processor.
• Refer to the ownerʼs manual of the connected equipment as well.
• When you connect the TV/DVD to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet
before making any connections.
• The output sound of the TV/DVD has a wide dynamic range. Be sure to adjust the receiverʼs volume to a moderate listening level.
Otherwise, the speakers and your hearing may be damaged by a sudden high volume sound.
• Turn off the amplifi er before you connect or disconnect the TV/DVDʼs power cord. If you leave the amplifi erʼs power on, the speakers
may be damaged.
Power source
To use AC power source
1. Open the AC INPUT cover.
2. Connect the AC cord plug into this TV/DVD's AC INPUT jack, then close the AC INPUT cover.
3. Connect the AC cord into an AC outlet.
Note:
• Never connect the AC line cord plug to other than the specified voltage (120V 60Hz). Use the attached power cord only.
• If the polarized AC cord does not fit into a non-polarized AC outlet, do not attempt to file or cut the blade. It is the user's
responsibility to have an electrician replace the obsolete outlet.
• If you cause a static discharge when touching the unit and the unit fails to function, simply unplug the unit from the AC outlet
and plug it back in. The unit should return to normal operation.
• If the AC cord plug is plugged in for the first time, wait for approx. 5 seconds before pressing POWER.
J51T0101D.indb 19 J51T0101D.indb 19
Digital audio input
75
Ω
Back side
coaxial cable (not supplied)
AC 120V, 60Hz
AC cord (supplied)
To COAXIAL DIGITAL
AUDIO OUT
AC Outlet
Wider Hole
and Blade
19
6/22/09 4:28:59 PM 6/22/09 4:28:59 PM