Section 1 − Installation And Operation; Typical Connection; Remote Amperage Control For Welding Power Source Without Remote Control Switch - Miller RFCS-5 Owner's Manual

SECTION 1 − INSTALLATION AND OPERATION
WARNING

1-1. Typical Connection

1
1-2. Remote Amperage Control For Welding Power Source Without
Remote Control Switch
Select Weld Process
2
Select Range And Polarity
READ SAFETY BLOCKS in welding power
source Owner's Manual before proceeding.
Turn Off welding power source.
1
2
Insert plug into matching 14-sock-
et, 5-socket, or 6-socket recep-
tacle, as applicable, on welding
power source. Tighten collar.
Approximately
Select Maximum
Amperage Percentage.
50% = Approx. 33 A DC
Foot Control
Remote 14, Remote 5, Or
Remote 6 Receptacle
Ref. 801 736
Off
0 A DC
On
33 A DC
Combination Front Panel
And
Remote Control
Press pedal lightly to turn
weld output and gas flow
on. Press pedal further to
increase weld output.
Release pedal to turn off
weld output and gas flow.
Ref. 155 790-E
OM-844 Page 1