Arctic Spas Custom Series Owner's Manual page 25

SOLUTIONS
A. Dirty Filter. If you are using a pleated filter clean with Arctic Pure Filter Restore. If you are us-
ing a disposable filter you may need to change the filter for a fresh one. If you believe the filter is
ok then try increasing the filtration times via the topside control, app, or via the web portal at
myarcticspa.com
®
B. Add Arctic Pure Easy Clear (Not with disponsable Filter)
C. Shock treatment with Arctic Pure
®
D. Add Arctic Pure Adjust Down until level reads 7.2-7.6
®
E. Add Arctic Pure Adjust Down to adjust TA level to 80-120 ppm
F. Shock treatment with Arctic Pure
G. Empty spa and refill
®
H. Add Arctic Pure Best Defence until level reads 100-280 ppm
®
A. Use Arctic Pure Best Defence and have your dealer check your water balance
®
B. Add Arctic Pure Boost treatment to raise chlorine levels and test chlorine levels.
C. Stop the use of fragrance
A. Shock treatment with Arctic Pure
A. Drain partially, add Arctic Pure
130 ppm.
A. Check pH and adjust as required.
B. Shock with Arctic Pure
C. Dilution of water will reduce contaminants and odor.
D. Check any ozone system is operational
A. Add Arctic Pure ® Adjust Up until level reads 7.2 - 7.6 ppm
B. Add Arctic Pure ® Refresh, add Boost.
C. Change from Bromine to Chlorine.
D. Drain and refill spa.
A. Add sanitizers until levels are up to the recommended levels
B. Replace test kits at least once a year
C. Chlorine level very high and is bleaching test reagent, Allow sanitizer levels to recede by open-
ing cover and running jets.
®
Refresh
®
Refresh
®
Refresh.
®
Best Defence, correct pH level to 7.2 - 7.6 and alkalinity to 100-
®
Refresh, add Boost.
25 25