Arctic Spas Custom Series Owner's Manual page 114

Owners Manual - Onzen™
Understanding Onzen™
*** IMPORTANT NOTICE ONZEN V8 ***
These cells are considered a consumable item and are now designed to be replaced by the
customer in order to be more user friendly. DO NOT GET THE INTERNAL CONNECTION WET!
To change your salt cell remove the set screw on your salt cell with a Phillips screwdriver. Now
unthread the salt cell from the housing turning counter clockwise. This will require you to use your
muscles as the cell is threaded in quite tight to prevent any water from getting on to the 12 volt
connection. Before threading in the new cell put a generous amount of dielectric grease in and
around the 12 volt connections in the centre of the housing and on the end of the cell. Now thread
the new cell into the housing. There is a notch built into the threads that will stop the cell precisely
where the set screw needs to be installed. If the cell is changed under water the connection will
get wet and corrode. The corrosion will destroy the connection between the salt cell and the salt
cell housing. This corrosion will be visibly noticeable upon inspection. Warranty will be void If
corrosion between the salt cell and salt cell housing is detected.
114 114