Chef CS910CS User Manual page 6

INSTALLATION INSTALLATION
PRE-INSTALLATION PRE-INSTALLATION
Before installing the cooker hood, peel off any protective Before installing the cooker hood, peel off any protective
plastic covering and remove polystyrene from inside behind plastic covering and remove polystyrene from inside behind
the fan motor. See diagram below. the fan motor. See diagram below.
LOCATION LOCATION
The underside of the hood body must be a minimum The underside of the hood body must be a minimum
of 600mm* above an electric cooktop and 650mm* of 600mm* above an electric cooktop and 650mm*
above a gas cooktop and a maximum height of 800mm. above a gas cooktop and a maximum height of 800mm.
*If the instructions of the hob specify a greater distance than the minimum above, *If the instructions of the hob specify a greater distance than the minimum above,
then that shall be the minimum height for installation. then that shall be the minimum height for installation.
6
INSTALLATION INSTALLATION
1. Using a spirit level mark a vertical centre line on the 1. Using a spirit level mark a vertical centre line on the
wall where the hood is to be positioned, and a wall where the hood is to be positioned, and a
horizontal line at the hood base position (refer horizontal line at the hood base position (refer
Fig. 6 below). Fig. 6 below).
2. Mark the location for flue cover wall mounting brackets 2. Mark the location for
and rangehood mounting points and anti-tilt fixing and rangehood mounting points and anti-tilt
points above the hood base using the hood base as points above the hood base using the hood base as
the reference point (Fig. 6 below). the reference point (Fig. 6 below).
25mm
23.5mm
270mm
250mm
36mm
GAS
Fig. 6
3. Install flue cover wall mounting brackets with suitable
fixings. Install suitable screws for rangehood mounting
points (to support a total weight of 30kg) to the wall as
marked (Fig. 7).
3. Install
xings. Install suitable screws for rangehood mounting
points (to support a total weight of 30kg) to the wall as
marked (Fig. 7).
ue cover wall mounting brackets
250mm
235mm
Ceiling
Flue cover
wall mounting
brackets
Rangehood
mounting points
Anti-tilt fixing points
250mm
250mm
580mm
580mm
ELECTRIC
Fig. 6
ue cover wall mounting brackets with suitable
xing
ceiling
Hood base
Top of hob
Min. 650mm
Max. 800mm