Chef CS910CS User Manual page 10

CARE & MAINTENENCE
WARNING
IMPORTANT: The hood must always be disconnected from the
electricity supply before beginning any maintenenace work.
Changing the lamps
If the lamps need replacing, they must be replaced by
lamps with an aluminium reflector, never dichronic lamps to
avoid unnecessary overheating in the lamp holders.
Ensure that the appliance is switched off before carrying
out maintenance to avoid any possibility of electric shock.
CAUTION
When handling lamps hold with a cloth or gloves to ensure perspiration
does not come into contact with the lamp as this can reduce the life of
the lamp.
TROUBLESHOOTING GUIDE
PROBLEM
The cooker hood will not start
The cooker hood is not working
The cooker hood has switched off
during operation
If you have completed all of the above checks and are still experiencing difficulty, please contact your local Electrolux
Service Centre.
10
User manual_CS910CS
REMEDY
Check that the hood is connected to an electrical supply
Check that a fan speed has been selected
Check that the fan speed is set high enough for the task
The grease filters are clean
The kitchen is adequately vented to allow the entry of fresh air
If set up for recirculation, check that the charcoal filter is still effective
If set up for extraction, check that the ducting and outlets are not blocked
The safety cut-out device has been tripped – turn off the hob and wait for the device to reset.
If the hood has been installed below the heights indicated in the installation instructions the
motor will cut out frequently which will damage the hood
Suitable lamp for replacement
For CRC914SB CRC914DB:
GU10 3.5W LED -> DBR-3.5-H-GU10-50/53
For CS910CS:
GU10 50W Halogen -> HAG-50-230-GU10-50/53
Picture of lamp: