Advertisement
Suspected malfunctions are often due to causes that the users can
fix themselves, therefore check the product using this section. In
most cases the problem can be solved quickly.
Problem
1. Product does
not start
2. Unsatisfactory
result
3. Product
suddenly
stops
WARNING!
instructions! All further inspection, maintenance and repair work must
be performed by an authorised service centre or a similarly qualified
specialist if you cannot solve the problem yourself!
TROUBLESHOOTING
Possible Cause
1.1 No power supply
1.2 Product damaged
1.3 Other electrical
defect to the
product
2.1 Drill bit is worn
2.2 Drill bit not
suitable for
intended operation
3.1 Product overloaded 3.1 Remove the
Only perform the steps described within these
1.1 Check the plug on
1.2 Check it by an
1.3 Check it by an
2.1 Replace with a new
2.2 Use suitable driver
IBL ID13-80|TD13-100
18
Solution
the power supply
electrician
electrician
one
bit
product from
the work-piece and
switch it on again
Hide quick links:
Advertisement
