iBell Tools IBL ID 13-80 Operator's Manual page 12

DRIVER/DRILL BITS
Different drill and driver bits can be used with this product
depending on the material being worked with.
INSERTING PROCEDURE:
1. Turn the chuck sleeve anticlockwise until the chuck jaws are opened
wide enough to insert the drill bit.
2. Insert the drill bit all the way to the stop. If using a 25 mm driver bit,
insert it into the socket of a bit holder.
3. Turn the chuck sleeve clockwise until the drill bit is properly fastened
in the chuck jaws.
1 -
-
REMOVING/REPLACING:
 Turn the chuck sleeve anticlockwise until the chuck jaws are opened
wide enough to remove the bit.
 Remove the bit and insert a new one as described above if desired.
WARNING!
Never use a drill bit intended for working on wood for working on
steel or vice versa! Observe the technical requirements of this
product when purchasing and using drill bits! Some drill bits become
hot during use, handle them carefully! Wear protective gloves!
Always use drill bits according to the intended use!
- 2 -
IBL ID13-80|TD13-100
11
- 3 -