Operating Other Devices; Programming The Remote To Operate Other Devices; Device Code Setup - Toshiba 46UL610U Owner's Manual

Operating other devices

Your TV remote control has one dedicated TV mode
and three programmable multi-brand modes: CABLE/
SAT, BD/DVD, and AUX.
Note: To operate a non-Toshiba device or a Toshiba
device that the remote control is not preprogrammed to
operate, you must program the remote.
Default device mode control (before
Mode select
programming)
TV Toshiba TV
CABLE/SAT Toshiba Satellite receiver
BD/DVD Toshiba Blu-ray Disc
AUX Onkyo Receiver
Device mode control (after
Mode select
programming)
TV Toshiba TV
CABLE/SAT
BD/DVD Multi-brand video/audio devices
AUX
Note: If you cannot program the TV's remote to operate
your device or some of its features, use the device's
remote or the controls on the device.
90
Chapter 10: Appendix
Programming the remote to
operate other devices

Device code setup

1
Find the code for your device brand in the remote
control device code table (- p. 93–98).
If multiple codes are listed, try each one separately
until you find one that works.
2
Press a mode select button (CABLE/SAT, BD/DVD,
or AUX). The button blinks 3 times.
While holding down Q, input the 4-digit code for
3
™
player
your device.
Result
2 blinks
1 long blink
4
Point the remote at the device. Press
code.
Result
The device responds.
The device does not
respond.
5
When programming is complete, test all necessary
keys on the TV's remote that operate your device. If
some keys are not operational, repeat the device
code setup using another code (if other codes are
listed for your device).
6
To control the TV, press TV.
7
If your VCR does not respond to the codes for your
VCR brand, and has a switch labeled VCR1/VCR2,
set the switch to the other position, then reprogram
the remote control.
Note: Every time you change the batteries, you must
reprogram the remote.
Meaning
Valid code
Invalid code
POWER to test the
Meaning
Valid code
Invalid code
Repeat the procedure, using
another code