Setting The Sleep Timer; Adjusting The Power Led's Brightness; Setting Automatic Power Down; Setting No Signal Power Down - Toshiba 46UL610U Owner's Manual

Setting the sleep timer

You can set the TV to turn off after a specific amount of
time (maximum = 12 hours).
Using the remote control:
Press [
1
2
Set the time until the TV turns off.
Repeatedly press [ to increase the time.
•
Press B or b to increase or decrease the time.
•
Using the onscreen menus:
1
> Settings > APPLICATIONS > Sleep Timer.
(Another: > Timer > Sleep Timer >
2
Enter the time until the TV turns off.
Use the number buttons.
•
Press C or c to increase or decrease the time.
•
Note: If a power failure occurs, the sleep timer setting may
be cleared.
To display the time remaining until the TV turns off:
Press [.
To cancel the sleep timer:
Press [ repeatedly or press B or b until it is set to 0
minutes.
Adjusting the POWER LED's
brightness
This feature allows you to adjust the POWER LED's
brightness.
1
> Settings > PREFERENCES > POWER LED.
2
Press C or c to select Bright or Dimmer. Press
Note: This operation is available only in 2D mode
52
Chapter 6: Basic features

Setting Automatic Power Down

The TV can be configured to automatically turn itself off
after 4 hours if you do not operate the TV either from
the remote control or the TV control panel.
1
> Settings > PREFERENCES > Energy Saving
Settings >
2
Press B or b to select Automatic Power Down.
3
Press C or c to select On. Press
Note: When the following features are set, the feature that
is set for the nearest time will function.
– Automatic Power Down
– Sleep Timer
.)
O K
– Wallpaper/Auto Power Off
– Auto shutdown after 1 hour of inactivity (after powering
on by On Timer)
– No signal auto power off (after 14 minutes of no signal)

Setting No Signal Power Down

When an input's setting in this feature is set to On, The
TV will automatically turn itself off after 14 minutes if
no signal is detected.
You can change each input's setting to Off: ANT/
CABLE, Video 1, Video 2, ColorStream HD1,
ColorStream HD2, HDMI 1, HDMI 2, HDMI 3, HDMI 4,
PC
1
> Settings > PREFERENCES > Energy Saving
Settings. Press
2
Press B or b to select No Signal Power Down.
Press
3
Press B or b to highlight the item you want to
change.
. 4
Press C or c to select On or Off. Press
Note:
• Default setting for each input is On.
• A warning message will appear 1 minute before turning
off.
.
O K
.
O K
.
O K
.
.