Bosch Sensortec Application Board 3.0 User Manual page 13

Sensor prototyping platform
Hide thumbs Also See for Sensortec Application Board 3.0:
Table of Contents

Advertisement

Bosch Sensortec"|
Application Board 3.0 User Guide
(7) GPIO3/INT2
Assigned depending on Shuttle design.
Typically reserved for Interrupt 2.
Modifications reserved | Data subject to change without notice
Stabilization
Auxiliary I2C interface.
(7) GPIO6/OSDO
Assigned depending on Shuttle
design. Typically reserved as the
sensor Data-out for the Optical
Image Stabilization (OIS) interface.
(8) GPIO7/ASDx
Assigned depending on Shuttle
design. Typically reserved as the
Data-in for
Stabilization (OIS) interface or Data
for the Auxiliary I2C interface.
(9) PROM-RW
This pin is used to connect to the 1-
Wire EEPROM to identify the
Shuttle Board 3.0 connected.
13 | 22
(OIS)
interface
or
the Optical Image
Document number: BST-DHW-AN008-00

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sensortec Application Board 3.0 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents