Operation - Husqvarna DM 200 Operator's Manual

• Maintain power tools and accessories. Check for
misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the
power tool's operation. If damaged, have the power
tool repaired before use. Many accidents are caused
by poorly maintained power tools.
• Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
schedule on page 13 .
3. Make sure that the nominal voltage and current in
the power outlet is the same as the voltage and
current of the product.
4. Make sure that the PRCD is started. Refer to
on page 10 and To examine the PRCD on page 10 .
5. Make sure that the work area is clean and bright.
6. Use personal protective equipment. Refer to
Personal protective equipment on page 9 .
7. Make sure that the product is installed correctly. The
drill bit must be attached correctly.
8. The auxiliary handle must be connected and fully
To use the auxiliary handle on
tightened. Refer to
page 11 .
9. When you operate the product dry, use a dust
To prepare the product for dry
extractor. Refer to
drilling on page 11 .
10. When you operate the product wet, make sure that
the water system is not damaged and use the water
To prepare the product for wet
connector. Refer to
drilling on page 11 .
To use embedded connectivity
Note: This part is applicable only for products supplied
with embedded connectivity.
Note: Radio transmission by the Bluetooth
be enabled on the first time of connection to a power
outlet, and stay on after that.
1. Download the Husqvarna Fleet Services iOS or
Android app Husqvarna Fleet Services.
2. Go to Husqvarna Fleet Services website https://
fleetservices.husqvarna.com for more information.
1416 - 004 - 02.07.2020
•

Operation

To use the handheld product
1. Always use a drill bit with a max diameter of 80 mm
Maintenance
2. Lock the auxiliary handle firmly in place prior to
3. Do not perform drilling from a ladder. Drilling in these
PRCD
To use the auxiliary handle
(Fig. 13)
1. Turn the handle counterclockwise to release it.
2. Move the handle around the spindle shaft to an
3. Turn the handle clockwise to lock it. Tighten fully.
To prepare the product for dry drilling
1. Attach the dust extractor connector to the mounting
®
function will
2. Attach the dust extractor to the dust extractor
3. Start the dust extractor.
To prepare the product for wet drilling
Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
with hand-held drilling. The larger the drill bit, the
greater the reaction if the drill jams.
To use the auxiliary handle on page
drilling. Refer to
11 . (Fig. 11)
situations is full of risks, as the risk of falling is very
high if the drill bit jams. (Fig. 12)
applicable operation position.
WARNING: Dust is made when you drill,
which can cause injuries if breathed in. Use
approved breathing protection.
WARNING: Do not use a house-hold
vacuum cleaner. Use only designated dust
extractors for hazardous dust. Refer to
Accessories on page 17 for minimum
properties.
thread on the product.
connector. (Fig. 14)
CAUTION: Make sure that the maximum
water pressure is not too high. Refer to
Technical data on page 16 .
11