Toshiba S3 User Manual page 130

130
Learning the Basics
Powering down the computer
Going into Standby mode more quickly
You can put the computer into Standby mode by either
pressing the power button or closing the display panel. You
can also specify an amount of time after which the computer
automatically goes into Standby mode.
To use any of these methods, you first need to enable them in
Toshiba's Power Saver utility.
1 Click Start, Control Panel, then Performance and
Maintenance.
2 Click the Toshiba Power Saver icon.
3 Click the Setup Action tab.
4 Select Standby for the options you want.
❖
❖
5 Click Apply.
6 Click OK.
NOTE
Starting again from Standby mode
To start up the computer from Standby mode, press the power
button until the on/off light changes to green. The computer
returns to the screen you were using.
When I press the power button
Set this option to Standby to put the computer into
Standby mode when you press the power button.
When I close the lid
Set this option to Standby to put the computer into
Standby mode when you close the display panel.
For more information about the Power Saver utility, see
"TOSHIBA Power Saver" on page 178.