Table of Contents
Advertisement
Floorboard Installation (Models with Aluminum Floors)
Quicksilver inflatable boats that are equipped with an inflatable or a
non‑inflatable floorboard must be operated only with these floorboards properly
installed. Using the boat without provided floorboard is unsafe, uncomfortable,
and might result in damage to the boat.
IMPORTANT: The floorboards must be installed into the boat before the boat is
inflated.
Install the removable seat before the boat is fully inflated.
•
Inflate the boat including the keel section (see the section on inflation).
•
Ensure that no parts of the tubes stick together.
•
Deflate the keel, and deflate the boat for about 2/3.
•
Place the front section (bow board 1) of the floorboard as far in the front of
the boat as possible. Make sure the hole in the bottom is straight above
the valve of the keel section. Place the side with the sticker face down.
•
Place part two into the boat. Put the two parts of the floorboard in line.
•
Take part three and eventually part four of the floorboard.
•
Push down the two parts to the bottom of the boat.
•
Inflate the keel approximately 5–10 strokes. The floorboards will be in a
level position.
•
Deflate the side‑tubes of the boat completely and install the aluminum
stringers.
INSTALLING THE ALUMINUM STRINGER
After installation of the floorboards, place the stringers (A) in the sides of the
floor (B) next to the tubes (C). Quicksilver models vary in lengths and number
of stringers. The length of the stringer should be evenly distributed over the
length of the floorboard.
To install the stringers easier, it is recommended to put an oar (paddle) under
the bottom of the boat. This lifts up the floorboards to have easier access to put
the stringers on the sides of the floor.
Air Deck® Floor Installation (Models with Air Floor)
Instructions for installing floorboards in Quicksilver models with an inflatable
floor.
ASSEMBLY AND DISASSEMBLY
18
71773
eng
Hide quick links:
Advertisement
Table of Contents
