Epson EMP-7850 Operation Manual page 10

Creating and Sending a Scenario
PROCEDURE
1 After the scenario is complete, select "Scenario
Option" - "Send Scenario".
Insert into a card adapter if a card adapter is needed.
2 A dialogue box for designating the destination drive
is displayed. Select the drive where the memory card
is inserted and click "OK".
3 A confirmation message is displayed. Click the "OK"
button.
4
Upon completion of transfer, a message is displayed
confirming whether autorun setup is to be performed.
To set up autorun or continuous play, click the "OK"
button and perform the following steps. To set
nothing, close out by clicking the "Cancel" button.
5
All scenario files within the memory card are
displayed in the Scenario List on the left.
In the case of automatic projection at projector power ON, click the
desired scenario name in the Scenario List, and click the " " button.
The scenario is displayed in the Autorun Scenario List on the right,
and is set as an autorun file.
To automatically go back to the beginning once the scenario
projection has finished, select the desired scenario in the Scenario
List and select "Revive".
TIP
Autorun can be set even if "Scenario Option" - "Edit Autorun" is selected.
•
Autorun setting cannot be designated in the EasyMP CardPlayer.
•
If there are two or more files set for autorun, they will be played back in
•
order on the Autorun Scenarios List.
6 Insert the memory card from the senario sending
function in the projector, and use CardPlayer on the
projector to project the scenario. s
EasyMP Operation Guide
9
p.21