Operation - Extech Instruments RHT10 User Manual

Operation
System Software Required:
Minimum Hardware Required:
INSTALLING THE GRAPHING SOFTWARE and USB driver
Install the supplied Windows PC Datalogger Software by placing the supplied program disk in the
PC's CD‐ROM drive or by downloading the program from the
http://Extech.com/instruments/software.asp web page.
If the installation program does not automatically open and provide on‐screen prompts, open and
browse the CD‐ROM drive, then find and double‐click on the SETUP.EXE file included on the
program disk. Follow the on‐screen prompts to complete the installation.
Software Install
USB Driver Install
Find Quality Products Online at:
Windows 7, Windows 8.1 or Windows 10
PC or Notebook with Pentium 90MHz or higher 32 MB RAM;
At least 7 MB of hard disk space available to install Datalogger USB software.
Recommended display resolution 1024X768 with High Color(16 bit).
Run SETUP.up.exe and follow the defaults to install he RTH10 software
1. Open the root folder of the RHT10.
2. Open the folder Driver\DriverUSBXPRESS and double‐click on USBXpressInstaller.exe.
3. Follow the default choices to load this USBXpress driver.
Note: When the RHT10 is connected to the USB port, the battery inside the device is discharged at
a higher rate than normal. To conserve battery life, do not leave the RHT10 connected to the USB
port for a prolonged period of time
GlobalTestSupply
www.
4 RHT10 HW_SW-en-US_V5.6.2 6/16
.com
sales@GlobalTestSupply.com