Table of Contents
Advertisement
k) Mounting the rubber feet
Slide the supplied rubber feet onto the ends of the legs.
You can also secure the rubber caps with some glue (e.g., Uhu
similar) so that they are not lost during operation.
The rubber feet not only secure a good grip on the ground, but also ensure
that the aluminium legs do not scratch the ground (floor, table etc.).
l) Setting jumpers
Finally, the two jumpers are plugged in. The jumper for the infrared receiver is plugged on "IR-U"; the jumper J7 is plugged only on one pin.
If you connect jumper J7 to both pins, the gamepad will be deactivated!
40
All Purpose Glue or
®
Figure 66
Figure 65
Advertisement
Table of Contents
