C) Mounting The Servo Disks - Maker Factory MF-4992453 Operating Instructions Manual

c) Mounting the servo disks

Mount the servo disks as described in the following illustrations. Use two M2 screws + nut for each servo disk. The other holes remain free!
These screws (all M2) are now already provided with a screw lock.
Required tool:
PH1 Phillips screwdriver
Small flat nose pliers or wrench for M2 nut (SW4)
Screw locking (medium strength)
Mounting the servo discs on the upper plate:
Figure 29 shows the top plate from above!
Figure 30 shows the top plate from below!
22
Figure 29
Figure 30