Table of Contents
Advertisement
j) Installing the battery
The battery is mounted edgeways with the supplied Velcro fastener as shown in the
illustrations. To do this, shorten the Velcro fastener to approx. 25 cm. Tighten the Velcro
so that the battery has a firm grip on the battery plate and cannot slip during operation.
Then run the cable through the top plate as shown in Figure 64a. Screw the battery
retaining plate to the lower plate. Use the screws M4 x 5 mm for this purpose.
In Figure 64b (see also Figure 7) you can see how the battery is plugged into the Ro-
bobug. The plug is protected against reverse polarity and cannot therefore be plugged
in the wrong way.
Figure 63
Figure 64a
Figure 64b
39
Advertisement
Table of Contents
