Parts List / Suggested Tools; Plumbing; Electrical; Uncrating And Inspection - Perlick DP32B Installation And Operation Instructions Manual

SINGLE KEG BEER DISPENSER SINGLE KEG BEER DISPENSER
Operation/Installation Manual Operation/Installation Manual
Parts List
■ Casters*
■ Faucet Standard
■ Faucet Head Assembly
■ Spanner Wrench for Faucet
■ Black Connector Hose 3⁄16" x 3'
■ 5⁄16" Air Hose
■ Bag of Miscellaneous Parts
■ Plastic Waste Bottle*
* Portable Model Only
Suggested Tools
■ Casters*
■ Faucet Standard
■ Faucet Head Assembly
■ Spanner Wrench for Faucet
■ Black Connector Hose 3⁄16" x 3'
■ 5⁄16" Air Hose
■ Bag of Miscellaneous Parts
■ Plastic Waste Bottle*
* Portable Model Only

Plumbing

Portable Model
No plumbing connections are required. Condensate
from the cooling coil is automatically evaporated.
Beer Drainer waste is accumulated in the plastic bottle
installed inside the cabinet.
Underbar Model
Features a floor drain with a 3⁄4" female pipe thread
connection for disposal of both condensate and
beer waste. Remove bottom 1" NPS or side 3⁄4"
drain plug attach male pipe to create external drain.

Electrical

The cabinet must be connected to a separately
fused power source (see electrical specification
plate) and grounded in accordance with National
and Local Electrical Codes. Caution: Do not
attempt to operate the equipment on any other
power source than that listed on the Electrical
Specification plate.
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice

Uncrating and Inspection

The cabinet must be connected to a separately
fused power source (see electrical specification
plate) and grounded in accordance with National
and Local Electrical Codes. Caution: Do not
attempt to operate the equipment on any other
power source than that listed on the Electrical
Specification plate.

Installing Casters

Attach four casters to the cabinet bottom; rigid
casters at the rear and swivel casters on the
front. Use the supplied 1⁄4"- 20 x 3⁄4" hex head
self-tapping machine screws.

Leveling the Cabinet

When the cabinet is in place, check installation
with carpenter's level. When perfectly level,
accumulated water will drain out. A slight pitch
to the drain side will not harm the cabinet. Water
may accumulate if cabinet is pitched to the
opposite side.
Installing the Faucet and
Dispensing Head
Before you begin: Wash dispensing head and
faucet.
Flush beer, dispensing head and faucet lines
with fresh water.
■ Apply RTV around the base of the dispensing
head to seal it to the top. Align the dispensing
head over the five holes on the cabinet top
and use the five stainless steel #10-32 x 13⁄4"
Phillips pan head stainless steel machine
screws to secure standard to cabinet top.
Wipe off excess RTV to complete the seal.
■ Attach faucet to standard using spanner
wrench to tighten coupling. Attach faucet
handle to faucet.
■ Insert flexible plastic air hose six to seven
inches into bottom of faucet standard.
Secure hose with tie wrap (supplied).
2
(Portable Models Only)