Honda SC65 Installation, Maintenance & Operation Manual page 91

9. Install the left brake caliper and tighten
the mounting bolts.
Torque: 23 lbf·ft (31 N·m, 3.2 kgf·m).
u Take care to prevent the brake caliper
from scratching the wheel during
installation.
u Use new mounting bolts when
installing the brake caliper.
NOTICE
When installing the brake calipers into position on
the fork legs, carefully fit the brake disc between
the pads to avoid scratching them.
10. Lower the front wheel on the ground.
11. Apply the brake lever (CB1100A: the
brake lever and brake pedal) several
times. Then, pump the fork several times.
Tire Puncture
12. Retighten the left axle pinch bolts.
Torque: 19 lbf·ft (26 N·m, 2.7 kgf·m).
13. Remove the protective tape or cloth.
14. Raise the front wheel off the ground
again, and check that the wheel rotates
freely after you release the brake.
If a torque wrench is not used for installation,
see your dealer as soon as possible to verify
proper assembly.
Improper assembly may lead to loss of
braking capacity.
u Removing Wheels
continued 89