Honda SC65 Installation, Maintenance & Operation Manual page 74

Drive Chain u Adjusting the Drive Chain Slack
4. Turn both adjusting bolts an equal
number of turns until the correct drive
chain slack is obtained. Turn the
adjusting bolts counterclockwise to
tighten the chain, or clockwise to
provided more slack.
Adjust the chain slack at a point midway
between the drive sprocket and the rear
wheel sprocket.
Check the drive chain slack.
5. Check rear axle alignment by making
sure the rear end of the swingarm aligns
with the corresponding scale on the
adjuster.
Both left and right swingarm ends should
align with the same mark on the
corresponding scale. If the axle is
misaligned, turn the left or right
adjusting bolt until the marks
correspond.
72
6. Tighten the rear axle nut.
Torque: 83 lbf·ft (113 N·m, 11.5 kgf·m).
7. Tighten the adjusting bolts lightly.
8. Recheck drive chain slack.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
P. 70
2
braking capacity.