Adjusting The Roller Scraper; (Optional) - Toro Groundsmaster 4300-D Operator's Manual

2
Removing the Shipping
Blocks and Pins
No Parts Required
Procedure
1. Remove and discard the shipping blocks from
the cutting decks.
2. Remove and discard the shipping pins from the
cutting deck suspension arms.
Note:
The shipping pins stabilize the cutting
decks during shipping; remove the pins before
operating the machine.
3
Adjusting the Roller
Scraper (Optional)
No Parts Required
Procedure
The optional rear roller scraper is designed to work
best when there is an even gap of 0.5 to 1 mm (0.020
to 0.040 inch) between the scraper and roller.
1. Loosen the grease fitting and the mounting
screw (Figure
1. Roller scraper
2. Mounting screw
2. Slide the scraper up or down until a gap of 0.5 to
1 mm (0.020 to 0.040 inch) is achieved between
the rod and the roller.
3. Torque the grease fitting and screw to 41 N∙m
(30 ft-lb) in an alternating sequence.
10
3).
Figure 3
3. Grease fitting
g011346