Raising The Machine; Lubrication; Greasing The Bearings And Bushings - Toro Groundsmaster 4300-D Operator's Manual

Raising the Machine

Use the following as points to jack up the machine:
•
Front of the machine—rectangular pad, under
the axle tube, inside each front tire
Figure 59
1. Front jacking point
•
Rear of the machine—rectangular axle tube on
the rear axle.

Lubrication

Greasing the Bearings and
(Figure 59).
Bushings
If you operate the machine under normal conditions,
lubricate all grease fittings for the bearings and
bushings after every 50 hours of operation with No.
2 lithium grease. Lubricate bearings and bushings
immediately after every washing, regardless of the
interval listed.
The grease fitting locations and quantities are as
follows:
•
Pump driveshaft U-joint
g031850
•
Cutting unit lift-arm cylinders (2
•
Lift-arm pivots (1
48
(3)—Figure 60
Figure 60
each)—Figure 61
Figure 61
each)—Figure 61
g003962
g011612