Greasing The Bearings And Bushings - Toro ProLine H800 Operator's Manual

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours—Grease the
bearings and bushings. When
operating the machine in extremely
dusty and dirty conditions, lubricate
the bearings and bushings daily.
Grease specification: No. 2 lithium grease
Important:
Dusty and dirty operating conditions
could cause dirt to get into the bearings and
bushings, resulting in accelerated wear.
Note:
Lubricate the grease fittings immediately after
every washing, regardless of interval specified.
1. Wipe grease fitting clean so debris is not forced
into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
The bearing and bushing lubrication points are as
follows:
•
Brake and traction pedal pivot bushings
43)
Figure 43
•
Rod fittings for the deck-lift cylinders
(Figure
g236053
g236026
44
(Figure
Figure 44
44).
g236051
g235949