Toro ProLine H800 Operator's Manual page 66

Figure 92
1. Hole (PTO-clutch plate)
2. Pin (anti-rotation tube)
8. Loosen the nut for the idler-pulley tensioner;
refer to Figure 89
Tension (page 65).
9. Rotate the idler pulley toward the engine and
remove the belts from the machine
Figure 93
3. Anti-rotation tube
in Checking the PTO Belt
(Figure
Installing the PTO Belts
1. Align the be PTO belts over the pulleys
94).
g232325
93).
1. Clutch pulley
2. Idler pulley
2. Align the pin of the anti-rotation tube with the
hole in the PTO-clutch plate; refer to
in Removing the PTO Belts (page
3. Secure the anti-rotation tube to the right engine
mount with the 2 bolts and 2 nuts that you
removed in step
(page 65).
4. Hook the clutch-damper spring between the
g232232
inboard clutch-plate bolt and the spring bracket;
refer to
(page 65).
5. Tighten the nut for the idler-pulley tensioner;
refer to
65).
6. Close the radiator to the machine; refer to
Accessing the Engine from the Right side (page
49).
66
Figure 94
3. PTO-shaft pulley
6 of Removing the PTO Belts
Figure 90 in Removing the PTO Belts
Checking the PTO Belt Tension (page
(Figure
g232323
Figure 92
65).