Advertisement
Note: To resolve resource conflicts or if you need options that are not found in the CDSETUP device-driver
installation program, refer to the READ.ME file on the Option Diskette. If you have problems installing the
device driver, refer to the CDSETUP program help information.
Installing the Device Driver for Windows NT 3.51:
1. Start Windows.
2. Click on the Start button and open the Main folder.
3. Click on Control Panel.
4. Double-click on Devices.
5. Click on atapi.
6. Click on Startup.
7. Click on Boot.
8. Click on OK.
9. Click on Cdfs.
10. Click on Startup.
11. Click on System.
12. Click on OK.
13. Click on Close.
14. Close the Control Panel.
15. Shut down and restart the computer.
See the Windows NT installation guide for more information.
Installing the Device Driver for Windows NT 4.0:
Windows NT version 4.0 should automatically detect the presence of the IDE CD-ROM drive. No additional
steps are required to activate the device drivers.
Some IBM Windows NT pre-loads contain a piixide device driver. This device driver replaces the Windows NT
native atapi device driver, and provides DMA support. The IDE CD-ROM will not work if both the atapi and
piixide device drivers are enabled at the same time. If this occurs, go into the Control Panel and set the
Startup parameter of one of the drivers to Disabled.
Using the Drive:
This section includes instructions for the proper care of CDs and the care and operation of your CD-ROM
drive.
Caring for a CD:
CDs are high-density media that must be handled with care and kept clean to insure that they remain
readable. These precautions will help to prolong the life of your CDs. Attention: Wiping a CD using a circular
motion can cause loss of data.
Advertisement
