Advertisement
1 - Headphone jack. This jack provides audio output to the headphones.
2 - Volume control. This controls the audio output volume.
3 - Busy indicator. This light comes on when the drive reads a data CD or plays an audio CD.
4 - CD tray. This is where you load and unload a CD.
5 - Manual-eject hole. This provides access to the manual eject mechanism to remove a CD from the drive.
Note: Your CD-ROM drive will have a manual-eject hole in one of the positions in the illustration, but not both.
6 - Eject/Load button. Opens and closes the CD tray.
1 - Reserved.
2 - Audio-out connector. Connects the analog audio signals to a sound adapter.
3 - Configuration pins. Sets the drive configuration.
4 - IDE connector. Connects the CD-ROM drive to the IDE cable.
5 - DC power connector. Connects the dc power cord to the CD-ROM drive.
Before You Begin:
Read the following information before you start your installation. The installer of the drive will have to complete
the following steps:
- Determine which IDE port to use, and the corresponding configuration setting.
- Set the configuration jumper on the drive (and possibly make changes to the configuration settings of other
devices.)
- Physically install the drive in a drive bay.
- Configure the system.
- Install a device driver.
If you do not understand these procedures, or are unsure about your ability to perform all the procedures
described, have a qualified computer technician install the CD-ROM drive for you, or call an IBM technical-
support representative.
Installation Requirements:
Before you begin installing the drive, be sure you have everything you need, such as:
Documentation:
You might need the documentation that comes with your computer, operating system, or IDE bus adapter if it
is separate from the computer.
Minimum Processor:
Advertisement
