Table of Contents
Advertisement
Changing the Hydraulic
Return Filter
Service Interval: After the first 50 hours
Every 500 hours
1.
Remove the return filter.
2.
Wipe oil onto the new return filter gasket.
3.
Install the new return filter to the machine.
Figure 49
Left side of machine
1. Hydraulic fluid return filter
Checking the Rear Wheel
Alignment
Service Interval: Every 500 hours
To prevent excessive tire wear and ensure safe
machine operation, the rear wheels must be correctly
aligned to 3 to 8 mm (0.12 to 0.31 inch).
1.
Set the rear wheels in the straight ahead
position.
2.
Measure and compare the distance between
the front sidewalls and the rear sidewalls at the
wheel center height.
Note:
The distance between the front sidewalls
must be set 3 to 8 mm (0.12 to 0.31 inch) less
than the distance between the rear sidewalls.
1. Wheel center height
g014491
2. Tire
To adjust the alignment of the rear wheels, first
back off the left and right locknuts on the track rod
assembly. (The left locknut has left-hand threads).
Rotate the track rod to achieve the correct distance as
described above and tighten the locknuts securely.
43
Figure 50
3. Direction of forward travel
4. Track-rod assembly
g014442
Advertisement
Table of Contents
