Table of Contents
Advertisement
4.
Fill the tank until the level is to the bottom of the
filler neck with diesel fuel.
5.
Install the fuel tank cap tightly after filling the
tank.
Note:
If possible, fill the fuel tank after each
use. This will minimize possible buildup of
condensation inside the fuel tank.
Hydraulic Fluid
Specifications
The reservoir is filled at the factory with high-quality
hydraulic fluid. Check the level of the hydraulic fluid
before you first start the engine and daily thereafter;
refer to
Checking the Level of the Hydraulic Fluid
(page
22).
Recommended replacement fluid: Toro PX
Extended Life Hydraulic Fluid; available in 19 L (5 US
gallon) pails or 208 L (55 US gallon) drums.
Note:
A machine using the recommended
replacement fluid requires less frequent fluid and filter
changes.
Alternative fluids: If Toro PX Extended Life
Hydraulic Fluid is not available, you may use another
conventional, petroleum-based hydraulic fluid having
specifications that fall within the listed range for all the
following material properties and that it meets industry
standards. Do not use synthetic fluid. Consult with
your lubricant distributor to identify a satisfactory
product.
Note:
Toro does not assume responsibility for
damage caused by improper substitutions, so use
products only from reputable manufacturers who will
stand behind their recommendation.
High Viscosity Index/Low Pour Point
Anti-wear Hydraulic Fluid, ISO VG 46
Material Properties:
Viscosity, ASTM D445
Viscosity Index ASTM D2270
Pour Point, ASTM D97
Industry Specifications:
Note:
Many hydraulic fluids are almost colorless,
making it difficult to spot leaks. A red dye additive for
the hydraulic fluid is available in 20 ml (0.67 fl oz)
bottles. A bottle is sufficient for 15 to 22 L (4 to 6 US
gallons) of hydraulic fluid. Order Part No. 44-2500
from your authorized Toro distributor.
cSt @ 40°C (104°F)
44 to 48
140 or higher
-37°C to -45°C (-34°F
to -49°F)
Eaton Vickers 694 (I-286-S,
M-2950-S/35VQ25 or
M-2952-S)
Checking the Level of the
Hydraulic Fluid
Service Interval: Before each use or daily—Check
the level of the hydraulic fluid.
1.
Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key from the ignition
switch.
2.
Check the sight level gauge on the side of the
tank.
Note:
The level needs to be at the upper mark.
3.
If additional hydraulic fluid is needed, clean the
area around the filler neck and the cap of the
hydraulic tank
1. Hydraulic-tank cap
2. Fluid tank
3. Sight level gauge
4.
Remove the cap and fill the tank to the upper
mark on the sight level gauge. Refer to
the Level of the Hydraulic Fluid (page
Note:
Do not overfill the tank.
5.
Install the cap onto the tank.
Checking the Tire Pressure
Check the air pressure in the front and rear tires.
Refer to the chart below for the correct pressure.
Important:
Maintain correct tire pressure in all
tires to ensure correct contact with the turf.
Tires
Tire Type
22
(Figure
27) and remove the cap.
Figure 27
Recommended Tire Pressures
Turf
Road
Conditions
Conditions
g014570
Checking
22).
Maximum
Pressure
Advertisement
Table of Contents
