Checking The Reel-To-Bedknife Contact - Toro Greensmaster TriFlex 3320 Operator's Manual

Removing the Cutting Units
1. Disconnect the cutting unit power disconnect
couplers; refer to
Connectors (page
CAUTION
If you do not disconnect the power
to the cutting units, someone could
accidentally start the cutting unit,
causing serious injury to hands and feet.
Always separate the cutting unit power
disconnect couplers before working on
the cutting units.
2. Park the machine on a clean level surface,
lower the cutting units to the ground until the
suspension hydraulics are fully extended, shut
off the engine, and engage the parking brake.
3. Push the motor retaining bar out of the slots on
the motor toward the cutting unit and remove
the motor from the cutting unit.
Figure 56
1. Reel motor
4. Move the motor to the storage location on the
front of the suspension arm
Cutting Unit Power Disconnect
22).
2. Motor-retaining bar
(Figure 57).
Note:
When sharpening, setting the
height-of-cut, or performing other maintenance
procedures on the cutting units, store the cutting
unit reel motors in the storage location on the
front of the suspension arms to prevent damage
to them.
Important:
the transport position when the reel motors
are in the holders in the machine frame.
Damage to the motors or hoses could result.
If you must move the traction unit without
the cutting units installed, secure them to
the suspension arms using cable ties.
5. Open the latches on the suspension-arm bar of
the cutting unit you are removing
6. Disconnect the latches from the cutting-unit bar.
7. Roll the cutting unit out from under the
suspension arm.
8. Repeat steps
units as required.
9. Connect the cutting unit power disconnect
couplers; refer to
Connectors (page
Checking the
Reel-to-Bedknife Contact
g036123
Each day before operating the machine, check the
reel-to-bedknife contact, regardless if the quality of cut
had previously been acceptable. There must be light
contact across the full length of the reel and bedknife;
refer to the Cutting Unit Operator's Manual.
Before checking the reels, disconnect the cutting
unit power disconnect couplers; refer to
Power Disconnect Connectors (page
them when finished.
49
Figure 57
Do not raise the suspension to
(Figure
3 through 7 for the other cutting
Cutting Unit Power Disconnect
22).
Cutting Unit
22). Connect
g036124
53).