Toro Greensmaster TriFlex 3320 Operator's Manual page 48

Figure 52
1. Footrest—closed
3. Position the cutting unit under the center
suspension arm.
4. With the latches on the suspension-arm bar
pointing up (i.e., open)
suspension arm down so that the bar fits over
the bar across the top of the cutting unit
54).
Figure 53
1. Latch—closed position
2. Suspension-arm bar
Figure 54
1. Suspension-arm bar
g014602
2. Footrest—open
(Figure 53), push the
(Figure
g014609
3. Latch—open position
g036343
2. Cutting-unit bar
5. Close the latches down and around the
cutting-unit bar and lock them in place
53).
Note:
You can hear a click and feel when the
latches are properly locked in place.
6. Coat the spline shaft of the cutting unit motor
with clean grease
7. Insert the motor into the left side of the cutting
unit (as viewed from the operator's position) and
pull the motor retaining bar on the cutting unit
toward the motor until you hear a click from both
sides of the motor
1. Reel motor
2. Spline shaft
8. Mount a grass basket onto the basket hooks on
the suspension arm.
9. Repeat this procedure for the other cutting units.
10. Connect the cutting unit power disconnect
couplers; refer to
Connectors (page
48
(Figure 55).
(Figure 55).
Figure 55
3. Cavity
4. Motor-retaining bar
Cutting Unit Power Disconnect
22).
(Figure
g036122