Commissioning; Battery Pack - Festool ISC 240 Li Instructions Manual

English
6

Commissioning

6.1 Switching on/off
The power tool features an on/off switch on
both sides. Use either switch to switch the pow­
er tool on or off.
Switching on
► Press the on/off switch [1-5] twice in quick
succession.
Switching off
► Press the on/off switch [1-5] once.
6.2 Selecting a cutting set
Only use cutting sets that have been ap­
proved by the manufacturer.
Two cutting sets, each available in two lengths,
are available for machining.
Cutting set with serrated saw blade (available
as an accessory depending on the model)
The cutting set with serrated
saw blade (SG-240/W-ISC,
SG-350/W-ISC) consists of a
guide rail with both a movable
and a fixed saw blade.
The cutting set with serrated saw
blade must be adjusted before initial
operation, see section
To ensure an optimum tool life for the
serrated saw blade, use a separate
cutting set for mineral wool and a
separate cutting set for natural fibres.
The saw blade is no longer suitable
for sawing natural fibres once it has
been used to saw mineral wool.
Cutting set with cross-set saw blade
(accessory)
The cutting set with cross-set
saw blade (SG-240/G-ISC,
SG-350/G-ISC) consists of a
guide rail and a movable saw
blade.
24
Insulating material
Flexible natural fibres
< 90 kg/m³
Flexible mineral wool
< 100 kg/m³
Pressure-resistant mineral
wool
100–170 kg/m³
PUR/PIR
< 36 kg/m³
Polystyrene
< 45 kg/m³
8.3 .
7
► Inserting the battery pack [2a]
► Removing the battery pack [2b]
7.1
The capacity display [2-1] indicates the charge
of the battery pack for approx. 2 seconds after
the button [2-2] is pressed:
*
before any further use.

Battery pack

Capacity display
Recommendation: Charge the battery pack
Further information about the battery
pack and charger can be found in the
corresponding operating manual.
Saw blade
70‑100%
40‑70%
15‑40%
< 15%
*