Mitsubishi Electric FR-E700EX Manual page 35

Stand-alone option
Name (Model)
Enclosure surface
operation panel
FR-PA07
DIN rail mounting
attachments
FR-UDA01
AC reactor
(for power
coordination)
FR-HAL-K
37
 Enables drive unit operation and monitoring of frequency setting, etc. from the enclosure surface.
 Approximate dimension
Item
Surrounding air temperature -10°C to +50°C (non-freezing)
Ambient humidity 90%RH or less (non-condensing)
Storage temperature -20°C to +60°C
Atmosphere Indoors (free from corrosive gas, flammable gas, oil mist, dust and dirt)
Altitude/vibration
Maximum 1,000m above sea level. 5.9m/s
Power supply Supplied from the drive unit.
Connection method Connection using the parameter unit connection cable (FR-CB20)
 Outline dimension and enclosure cut dimensions (Refer to page 7)
(Note)1. The operation panel cannot be removed from the drive unit.
2. The separate parameter unit connection cable (FR-CB20) is required.
 Supports installation of FR-E700EX series on a DIN rail.
 Approximate dimension
 When installed at the input side of the drive unit, this option improves the power factor and suppresses the input side harmonic current.
 Selection method
Select an AC reactor according to the applied motor capacity.
 Connection diagram
FR-HAL Drive unit
R X
R/L1
Three-phase
S Y
AC power S/L2
supply
T Z
T/L3
 Outline dimension
Model W D H
0.4K 104 72 99
0.75K 104 74 99
(Note)1. Make a selection according to the applied motor capacity.
2. Approximately 88% of the power factor improving effect can be obtained (92.3% when calculated with 1
power factor for the fundamental wave according to the Architectural Standard Specifications (Electrical
Installation) (2013 revision) supervised by the Ministry of Land, Infrastructure, Transport and Tourism of
Japan).
3. Outline dimension drawing shown is of a typical model. The shape differs according to each models.
4. Install the AC reactor (FR-HAL) on a horizontal or vertical plane.
Specifications, Structure, etc.
Specifications
68
67
15
3-M4 0.7 screw
Hook
Motor
U
V
M
W
Mass
(kg)
0.6
0.8
(Unit: mm)
2
or less
(Unit: mm)
Less than D
H
W