Toro Multi Pro 5800 Operator's Manual page 20

system pressure and proceed to the next
step.
•
If the volume is too high, use the
application-rate switch to lower the sprayer
system pressure and proceed to the next
step.
9. Repeat steps 4 through
fluid in the graduated catch container ± 7.4 ml
(1/4 fl oz) of the Target Volume displayed on the
InfoCenter screen.
10. Press button 2 to proceed to
Calibration Calculation (page
Performing the Calibration Calculation
1. Set the master section switch to the O
(Figure 53).
Figure 53
2. Press button 2 to advance to begin the
calibration calculation
Note:
The InfoCenter displays the calibration in
process screen (Figure
Note:
The sprayer sections sprays out for 3
minutes while the machine is calculating the
calibration correction.
8 until the volume of
Performing the
20).
position
N
g192853
(Figure 53).
54).
When the calibration process ends 1 of the
following messages is displayed:
•
A message displays confirming that the flow
calibration is successful
•
A message displays indicating that the flow
calibration has failed
20
Figure 54
(Figure 55).
Figure 55
(Figure 56).
Figure 56
g192852
g192866
g192865