Toro Multi Pro 5800 Operator's Manual page 16

Figure 41
3. Press button 4 to select Flow calibration option
(Figure 41).
4. Fill the sprayer tank half full—600 L or 150 US
gal of water (Figure
Note:
You can cancel the flow calibration
by pressing button 5. A message displays
confirming that you canceled the flow calibration.
Figure 42
5. Engage the parking brake
6. Start the engine and lower the outer sections.
7. Set the pump switch to the O
43).
42).
(Figure 42).
position (Figure
N
g192583
1. Sprayer-pump switch
2. Agitation switch
8. Move the throttle to the F
43) and allow the engine to run for 10 minutes.
Important:
system to operating temperature before
proceeding with the remaining flow
calibration steps.
Preparing for the Catch Test
1. Press button 2 to advance to the next step
(Figure 42).
2. Press buttons 3 or 4 to select the nozzles
installed at the active spray position as follows:
•
For machines with nozzle colors that match
the flow rates described in
the color of nozzles installed at the active
spray position.
g192582
•
For machines with nozzle colors that do not
match the flow rates described in
select the flow rate (gpm or lpm) of nozzles
installed at the active spray position.
16
Figure 43
3. Throttle
position
AST
You must bring the hydraulic
Figure
g192636
(Figure
44, select
Figure 44,