Toro Multi Pro 5800 Operator's Manual page 17

Figure 44
3. Press button 2 to advance to the next step
(Figure 44).
4. Set the sprayer mode switch to the manual
position (Figure 45).
Figure 45
1. Manual mode position
5. Rotate the knob for the section-bypass shutoff
valve to the closed position
g192605
g192606
g192608
2. Sprayer-mode switch
(Figure 45).
1. Section-bypass shutoff valve (closed position)
6. Set the agitation switch to the O
set the throttle to the F
7. Press button 2 to advance to the next step
(Figure 45).
Preparing the Sprayer Section(s) for the Catch
Test
1. Set the sprayer section switches as follows:
Note:
Refer to
(page 15).
•
Select the left, center, and right section
switches for a 3-sprayer-section
calibration.
Important:
calibration.
•
Select the 2 sprayer section switches for the
sprayer sections you identified in
the Which Type of Flow Calibration to
Perform (page 15)
calibration.
Note:
Perform this optional calibration after
performing the 3-sprayer-section calibration.
•
Select the left or center or right section
switch the sprayer section you identified
in Evaluating the Which Type of Flow
Calibration to Perform (page 15)
1-sprayer-section calibration
Note:
Perform this optional calibration after
performing the 3-sprayer-section calibration
and 2-sprayer-section calibration.
17
Figure 46
position and
FF
position (Figure
AST
Preparing for the Flow Test
You must perform this
Evaluating
for the 2-sprayer-section
for the
g192607
43).