Setup; Installing The Bit - Toro 23135 Operator's Manual

Setup

Refer to the Operator's Manual for your traction unit for
instructions on installing and removing the attachment.

Installing the Bit

1. Park the machine on a level surface.
2. Raise the horizontal breaker so that it is about 15 cm
(6 inches) off the ground.
3. Stop the engine and remove the key.
CAUTION
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you
do any maintenance.
4. Using a hammer and punch, remove the 2 elastic
pins out of the breaker housing to gain access to the
retaining pins (Figure
Note: Remove both front and rear pins.
1. Elastic pin
2. Retaining pin
3. Bit
5. Using a hammer and punch, remove the 2 bit-retaining
pins from the breaker housing
Note: Removing the bit-retaining pins may require
considerable force.
6. Apply grease completely over the top 15 cm (6 inches)
of the bit (Figure 2)
7. Slide the bit into the breaker with the 2 notches in the
bit in line with the retaining-pin holes
2).
Figure 2
4. Notch
5. Grease here.
(Figure 2).
(Figure
8. Hold the bit in place and insert the 2 bit-retaining pins
into the breaker housing
9. Drive the pins into place with a hammer
10. Insert the 2 elastic pins into the breaker housing and
drive them into place over the retaining pins with a
hammer
11. Grease the bit before use; refer to
(page
Note: To change bits, repeat this procedure.
2).
5
(Figure
(Figure 2)
8).
2).
(Figure 2).
Greasing the Bit