Table of Contents
Advertisement
How to Install Power Wires into TB
1.
Strip wire insulation back ½"
(12.5 mm)
3.
Insert wire fully into Terminal Block
5.
Pre-Delivery Instructions
12.5 mm
½"
Open Terminal Block by lifting lever
to the UP position
Close Terminal Block by lowering
lever to the DOWN position
IMPORTANT: Lever must be in the
FULL DOWN position to Lock wire
T:\TECH\Instructions\Finished\62359c Terminal Block Wiring 16.doc
Page 12
NOTE: In
into single lug below
terminal block
2.
4.
Repeat steps 1-4 to add
additional wires.
stall Ground
Hide quick links:
Advertisement
Table of Contents
