Alarm With Additional Information; Automatic Call After Alarm - ASCOM i63 User Manual

Alarm Operation
Reset Alarm
1 Reset the alarm in one of the following ways:
• Move the handset to an upright position (after Man-
down).
• Move the handset (after No-movement).
• Press the Mute button if the ALS sounds.
6.5

Alarm with Additional Information

Information about the approximate location of the handset is automatically sent along with an alarm, see
Associated Access Point (AP) Location, page
with Data, page 45.
• IR
• LF
• AP
• Alarm with Data
Associated Access Point (AP) Location
This function is used together with an alarm. The AP communicates to the handset where the handset is
located for the time being. This gives a fair indication of the location.
An approximate location of the handset is added to alarms sent from the handset. The handset sends the
current and previous AP location to indicate where the alarm was activated.
Alarm with Data
The data can be defined and stored manually by the user. To use the function, one Soft/Hot key/Navigation
key in the handset must be defined as a shortcut to the menu Edit alarm data, see
The stored data is added to all types of alarms at transmission.
6.6

Automatic Call after Alarm

A handset can be set up to call a predefined number after an alarm has been sent, for example to "112"
which is the common emergency call number inside the European Union.
Depending on the settings, the call can be established in the following modes:
• Loudspeaking mode
• Monitor mode
• Normal mode
For more information, refer to the Configuration Manual, Ascom i63 VoWiFi Handset, TD 93300EN.
45
PRELIMINARY
45. It is also possible to add the location manually, see
USER MANUAL
Ascom i63 VoWiFi Handset
Alarm
8.2 Shortcuts, page 55.
TD 93289EN / / Ver.