KN-DSP100 Quick Start Guide
This guide helps you install and use your KN-DSP100 for the first time.
Go to
upgrades are available.
Scan for full manual
Step 1: Check what's in the box
KN-DSP100 Kramer Network server with DSP
2 Power cord types (US + European)
Step 2: Get to know your KN-DSP100
#
Feature
1
Indicator LEDs
2
Reset Button
3
Power Button
4
Power Socket
5
RS-232 9-pin D-sub Connector
6
USB 2.0 Ports (2)
7
IPMI (Intelligent Platform Management
Interface ) LAN RJ-45 Connector
8
USB 3.0 Ports (2)
9
LAN 1 ETHERNET RJ-45 Connector
10
LAN 2 ETHERNET RJ-45 Connector
11
VGA 15-pin HD Port
KN-DSP100 Quick Start (P/N: 2900-300950QS REV 1)
www.kramerav.com/downloads/KN-DSP100
Function
Use to reboot the system.
Use to toggle setting the device to standby mode / turning the device on.
To turn the power off, disconnect the power connector from the mains.
Connect to the power cord and to the mains electricity.
Connect to a system controller.
Connect to a keyboard and mouse (if required)
N/A
Connect to USB devices.
Connect to the Ethernet.
Connect to the Ethernet.
Connect to a display.
to download the latest user manual and check if firmware
1 Set of rack ears
1 Quick start guide
Flashes to indicate fan failure.
Lights continuously to indicate system overheat.
Flashes when there is network activity on LAN port 2.
Flashes when there is network activity on LAN port 1.
Flashes to indicate hard drive activity.
Lights when the device is powered.
P/N: 2 9 0 0 - 3 0 0 9 5 0 QS
Rev: 1
Need help?
Do you have a question about the KN-DSP100 and is the answer not in the manual?
Questions and answers