Initial auto installation
Checking signal strength and
channel strength (DVB-T/T2*
2
S2*
)
If you install a DVB-T/T2/C/S/S2 antenna for the first
time or relocate it, you should adjust the alignment
of the antenna to receive a good reception while
checking the antenna setup screen.
636 series only
I
J
635 series only
Go to "Menu" > "Setup" > "View setting" >
1
"Channel settings" > "Antenna setup-DIGITAL".
Press a/b to select "Digital setup" or "Satellite
2
setup", and then press ;.
E
Checking signal strength
Press a/b to select "Signal strength", and then
3
press ;.
Signal strength for DVB-T/T2/C
Supply voltage
Signal strength
Channel strength
CH No.
Signal strength
Current
Quality
Current
Signal strength for DVB-S/S2
Signal strength
Channel strength
Signal strength
Current
Quality
Current
E
Checking channel strength
Press a/b to select "Channel strength", and
4
1
2
/C/S*
/
then press ;.
• You can input a specified frequency band using the
0_9 numeric buttons.
Channel strength of DVB-T/T2
Supply voltage
Signal strength
Channel strength
Channel strength of DVB-C
Supply voltage
Signal strength
Channel strength
Max.
Max.
Channel strength of DVB-S/S2
Signal strength
Channel strength
Max.
Max.
5
NOTE
• The values of "Signal strength" and "Quality" indicate
when to check the appropriate alignment of the
antenna.
Frequency
Supplying power to the antenna
MHz
CH No.
You must supply power to the antenna in order
Signal strength
to receive digitally/terrestrially broadcast stations
after connecting the antenna cable to the antenna
Current
Max.
terminal on the rear of the TV.
Quality
1
Current
Max.
2
Frequency
MHz
Symbol rate
QAM modulation
Signal strength
Current
Max.
Quality
Current
Max.
Frequency
MHz
Symbol rate
Band
Vert/Low
Signal strength
Current
Max.
Quality
Current
Max.
18
Position and align the antenna so that the
maximum possible values for "Signal strength"
and "Quality" are obtained.
Go to "Menu" > "Setup" > "View setting" >
"Channel settings" > "Antenna setup-DIGITAL" >
"Supply voltage".
Press c/d to select "On", and then press ;.