Supplying Electric Power To The Antenna; Initial Auto Installation - Sharp LC-42D83X Operation Manual

Preparation
Supplying electric power to the
antenna
When you set-up the DTV antenna for the fi rst time,
or connect the antenna to a community antenna, you
need to proceed to set the antenna by following this
manual.
Press MENU and the MENU screen displays.
1
Press c / d to select "Setup".
2
Press a / b to select "Antenna Setup-
3
DIGITAL" and then press ENTER.
Press a / b to select "Supply Voltage" and
4
then press ENTER.
Press c / d to select "On" and then press
5
ENTER.
Selected item
Select "On" when your antenna is set-up
On
and connected independently.
Off Select "Off" when you do not need to
supply voltage to your antenna, i.e. when
your antenna is connected to a community
antenna. (The factory default setting of this
function is "Off".)
52D83X_en_b.indd 11 52D83X_en_b.indd 11
Description

Initial auto installation

When the TV powers on for the fi rst time after purchase,
the initial auto installation wizard appears. Follow the
menus and make the necessary settings one after
another.
Confi rm the following before turning on the
power
• Is the antenna cable connected?
• Is the AC cord plugged in?
Press POWER on the TV.
1
• The initial auto installation wizard appears.
Setting the on-screen display language.
2
Press a / b to select the desired language,
3
and then press ENTER.
Press ENTER.
4
Major Analogue Channel settings are pre-set.
However, if there are any channel(s) that you
cannot receive with the factory pre-sets, please
perform "Auto Installation" in "Setup" section
(refer chapter "Watching TV" on manual).
Digital Search
• Major Analogue Channel settings are pre-set.
However, if there are any channel(s) that you
cannot receive with the factory pre-sets, please
perform "Auto Installation" in "Setup" section (See
page 20).
The TV searches for, sorts and stores all
5
the receivable TV stations according to their
settings and the connected antenna.
• To abort the initial auto installation in progress,
press END.
NOTE
• If you turn off the power on the TV after performing step 4,
the initial auto installation wizard does not appear. The auto
installation function allows you to execute the installation
again from the Setup menu. (Page 20)
• The initial auto installation wizard will go off if you leave the
TV unattended for 30 minutes before searching for channels
in step 5.
English
11
2007/08/31 16:24:50 2007/08/31 16:24:50