24S or 24S-D cabinet. No additional loads must be added. 1.3 Intended use The d&b Z5554 Horizontal bracket 24S must only be used in conjunction with d&b 24S or 24S-D cabinet loudspeaker as described in these mounting instructions.
The bracket is attached to the cabinet with hole [a] facing to the back of the cabinet. Both bolts are fitted into slot [b]. The vertical coverage angle can be set over a range of 15° starting from 0° to +15°. d&b Z5554 Mounting instructions 1.1 en...
To attach the bracket to walls or ceilings, use the holes shown in the graphic opposite to provide adequate support. A corresponding fixing template is supplied with these mounting instructions. Refer to Þ Chapter 2 "Z5554 Fixing template" on page 8. Preparing the cabinet The threaded inserts of the cabinet are covered by dummy caps in cabinet color.
6. On the opposite side, proceed in the same manner. 1.6 Adjustments To align the cabinet to its desired angle, proceed as follows: 1. Slightly slacken all screws. 2. Align the cabinet to its desired angle. 3. Finally tighten all screws. d&b Z5554 Mounting instructions 1.1 en...