Maintenance - Trane MW(C)W509 Installation & Operation Manual

Maintenance

•
•
•
Cleaning of panel
Remove it before cleaning: Do not do cleaning with water hotter than 45
otherwise it may be discolored or distorted.
1.
2.
3.
As shown in the fi gure below, put the panel pillars at both sides into channels and middle rotor
shaft into the slots. Finally cover the panel according to the arrow direction and fi x it.
Cleaning of air strainer
Generally, the air strainer is expected to be cleaned every three months. In case of operation in
a dusty environment, its cleaning frequency shall be increased.
1.
2.
20
Attention
Cleaning of air conditioning must be done with the unit stopped and its main power off,
otherwise the risk of electric shock may be resulted in.
Never wet the air conditioning, otherwise the risk of electric shock may be resulted in. Make
sure not fl ush the conditioner with water in any case.
Volatile liquids like thinner and gasoline may damage the appearance of air conditioning. (Its
enclosure could only be cleaned with soft dry cloth and wet cloth dipped with neutral wash
solution).
Attention
As shown in the fi gure below, apply force to slots at both panel sides in arrow direction to
remove the panel.
Clean the panel with soft brush, water and neutral cleanser, followed the drying with water
throw-off or in a cool place.
Reinstall the panel.
Remove the air strainer
As shown in the fi gure, apply force to slots at both panel sides in arrow direction to open
the panel and pull the air strainer downwards to remove it.
Cleaning of the air strainer
Generally, the strainer may be cleaned with dust remover or through water washing, and
may be washed in the warm water (below 45
dirty (e.g. oil dirt), followed the drying in a cool place;
) containing neutral cleanser if it is very
,
AMS-SVX03A-EN