Table of Contents
Advertisement
1. In the navigation system's normal view,
press the thumb wheel/OK/MENU and
Set destination
Latitude and
select
longitude.
2. Begin by deciding which type of GPS
coordinates are to be used by selecting
Format:
•
DD°MM'SS''
: location in degrees,
minutes and seconds.
•
Decimal
: location expressed in deci-
mals.
3. Enter the GPS coordinates.
For additional information about the des-
tination, select
Information
the type of information desired.
4. To store an address in the system's
memory, select
Save
followed by
location
Home
or
.
5. Set the address as an intermediate desti-
nation or a single destination:
•
Add as waypoint
: adds the address
as an intermediate destination (way-
point) to the itinerary.
•
Set single destination
: deletes any
previous destinations in an itinerary
and starts guidance to the selected
destination.
02 Setting a destination, itinerary and route
Setting a destination using a position on
the map
The cursor's position given in GPS coordinates.
To display the name, select
options
Position
followed by
1. In the navigation system's normal view,
press the thumb wheel/OK/MENU and
select
Set destination
Stored
map.
2. Move the cursor to the desired position,
see also Menus(p. 10) .
3. To store the position in the system's
memory, press the thumb wheel/OK/
MENU and select
Stored location
> the destination will be stored as a sym-
bol/icon on the map if the function
Stored location on map
see also Map alternatives (p. 27).
4. Set the address as an intermediate desti-
Setting a destination using the travel
guide
Searching using travel guide (not available in
Settings
Map
all areas) offers suggested destinations/
routes according to various themes such as
information.
restaurants, scenic drives, sight-seeing, etc.
A travel guide is stored on a USB flash drive
that has to be plugged into the vehicle's USB
Select point on
socket in the tunnel console storage com-
partment.
1. In the navigation system's normal view,
Save
followed by
Home
or
.
is selected,
nation or a single destination:
•
Add as waypoint
: adds the address
as an intermediate destination (way-
point) to the itinerary.
•
Set single destination
: deletes any
previous destinations in an itinerary
and starts guidance to the selected
destination.
press the thumb wheel/OK/MENU and
select
Set destination
Travel
If this menu alternative is not displayed,
this is because there are no suggestions
for your current location or no USB flash
drive is connected.
02
guide.
}}
19
Advertisement
Table of Contents
