Wiring; Rtu Input/Output - Hubbell GAI-Tronics HUBBCOM GSC3100 Quick Start Manual

Dual-port flush-mount smart controllers
Table of Contents

Advertisement

HUBBCOM™ GSC3100/GSC4100 Dual-Port Flush-Mount Smart Controllers

Wiring

HUBBCOM smart controllers have quick release terminal blocks that accept 18–24 AWG wires. Release
wires from the terminal block by pressing the quick release button above the terminal.
N
: Two clamp on ferrite cores are supplied with the smart controller. Double wrap all wires
OTE
terminating to terminal blocks TB1 and/or TB2 around a ferrite core. Install the clamp on ferrite
cores as close as possible to the terminal blocks.

RTU Input/Output

Terminal block TB1 is for optional RTU I/O (Remote Terminal Unit Input/Output) functionality.
Complete the following steps to terminate the RTU I/O cables:
1. Install appropriately sized ferrules onto the wire ends.
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-533F.docx
11/20
Figure 3. Flush-Mount Cutout Details
Pub. 42004-533F
Page 5 of 10

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GAI-Tronics HUBBCOM GSC3100 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Gai-tronics hubbcom gsc4100Gai-tronics hubbcom gsc3100

Table of Contents